Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Chimney Company in Lockhart, TX
Chimney repair in Lockhart means working on flues that are often 80 to 130 years old, built with brick and mortar that central Texas heat, occasional freezes, and decades of wood smoke have worked over. Oakgrove Chimney Sweep has served Lockhart since 2017, and most of the repair calls we run here trace back to the same root cause: an unlined or deteriorated flue in a home that was built long before modern fire codes existed. We diagnose what’s actually failing, show you photographic evidence from inside the flue, and fix it with contractor-grade materials rather than handing you off to a third party. Call (866) 472-2513 when you need a straight answer about your chimney.
Why Lockhart Homes Are Different
Lockhart’s historic district is full of Victorian and early-1900s homes, and an unusual number of them still have their original wood-burning fireplaces. That sounds charming until you run a camera up the flue and see what a century of use leaves behind: cracked tile liners, eroded mortar joints, and in some cases no liner at all, just raw brick. Central Texas heat compounds the problem. Fireplaces sit idle from roughly April through October, and during those months creosote hardens into a thick, glassy layer that’s far harder to remove than the soft, flaky buildup you’d brush out mid-season.
There’s another Lockhart-specific issue we deal with regularly, and it’s tied to the town’s barbecue culture. A meaningful number of residents burn post-oak scraps from their pits in the fireplace, or they vent indoor smokers into an existing flue. Barbecue wood produces a greasy, black residue that behaves differently from standard fireplace creosote. It clings to flue walls, it’s stubborn, and it can mask underlying masonry damage. We approach every Lockhart sweeping and inspection with that possibility in mind, because a standard job can turn into a repair job once the buildup comes off and the real condition of the flue is visible.
Sudden cold snaps are the other local wildcard. Lockhart can go from mild to freezing in a weekend, and when freeze-thaw cycles hit an old brick chimney that’s already lost some mortar, spalling and cracking accelerate. That’s why we recommend fall inspections before heavy burning season starts.
Styles & brands we work with





Our Main Lockhart Services
The two services Lockhart homeowners call about most are chimney sweeping and dryer vent cleaning. Here’s what each involves in this area.
Chimney Sweep in Lockhart
A chimney sweep in Lockhart is never just a brush through the flue. Given the age of the housing stock, every sweep here starts with a camera inspection so we can see liner condition, mortar joints, and any buildup that’s not visible from the firebox. In Lockhart specifically, we watch for hardened creosote left from long idle summers and grease residue from barbecue wood. The goal is to leave you with a clean, safe flue and a clear report of what we found, not just a receipt. Chimney Sweep in Lockhart has full pricing and what to expect.

Dryer Vent Cleaning in Lockhart
Dryer vent cleaning in older Lockhart homes matters because many of these houses have long, convoluted vent runs that were added decades after the home was built, often through attics or crawl spaces where lint accumulates against studs and insulation. Lint is fuel, and a clogged vent turns a dryer into a fire hazard. Our crew treats dryer vent cleaning as a combustion-safety service, not a side job, because we understand how heat, airflow, and flammable buildup interact in a vent pathway. Dryer Vent Cleaning in Lockhart covers the local signs you need it and what it costs.

What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Chimney Repair in Lockhart
Chimney repair in Lockhart is usually about restoring an older flue so it can handle another decade of wood fires safely. Most of the repair work we do here falls into two categories: water getting in where it shouldn’t, and liners that have cracked or were never installed in the first place. Our service hub page on Chimney Repair covers the full scope of what we fix, but the local version is this: we repair what we find, using the same materials chimney contractors trust, and we show you the damage before we quote the fix.
Chimney Cap Installation
Signs you need it
You see rain streaking down the outside of the chimney, hear birds or animals in the flue, or notice rust stains on the firebox floor after storms.
What it costs in Lockhart
Chimney cap installation in Lockhart typically runs $185 to $350 depending on flue size and whether a custom bracket is needed for an odd-sized old flue.
How we do it
We measure the flue opening, select a properly sized stainless or copper cap, secure it to the crown with mechanical fasteners, and confirm the mesh spacing still allows adequate draft.
Chimney Liner Installation
Signs you need it
Your camera inspection shows cracked or missing clay tiles, gaps between tile sections, or an unlined flue in a home built before the 1940s.
What it costs in Lockhart
Chimney liner installation in Lockhart generally runs $2,100 to $4,800, with the variance driven by flue height, accessibility, and whether we’re relining from the top down or through the firebox.
How we do it
We remove the old tile if it’s collapsing, size a DuraFlex stainless liner to the appliance and flue dimensions, drop it in through the top, connect it at the appliance collar, and pour insulation where the void space requires it.
Chimney Flashing Repair
Signs you need it
You see water stains on the ceiling near the chimney chase, efflorescence on the brick below the roofline, or peeling paint where the chimney meets the roofline.
What it costs in Lockhart
Chimney flashing repair in Lockhart typically ranges from $275 to $650, depending on how much of the step and counter flashing has to be removed and replaced.
How we do it
We cut back the old flashing, install new step and counter flashing with proper shingle overlap, seal the joint with a polyurethane caulk rated for masonry, and repoint any mortar we disturbed at the roofline.
Chimney Crown Repair
Signs you need it
Your crown is cracked, spalled, or pooling water, and you see mortar crumbs accumulating at the top of the chimney or staining running down the brick face.
What it costs in Lockhart
Chimney crown repair in Lockhart runs $450 to $1,250, with the spread depending on whether we’re resurfacing a cracked crown or rebuilding it completely with proper expansion clearance.
How we do it
We clean out failed material, form or trowel a new crown with a slight slope away from the flue, install a bond break so the crown can move independently, and finish with a breathable masonry sealant.
What Chimney Repair Costs in Lockhart
| Item | Typical range in Lockhart |
|---|---|
| Chimney cap installation | $185 – $350 |
| Chimney flashing repair | $275 – $650 |
| Chimney crown repair | $450 – $1,250 |
| Chimney liner installation | $2,100 – $4,800 |
Do I really need a new chimney liner?
If the old clay tiles are cracked, missing, or separated enough that flue gases can reach the surrounding brick, yes. An unlined or failed liner lets heat and carbon monoxide move through mortar joints into wall cavities, and in a 1920s Lockhart home those cavities are often adjacent to old, dry framing. A camera inspection settles it in ten minutes.
Can a cracked chimney crown wait until spring?
It depends on the cracks. Hairline cracks usually can, but if water is actively pooling or you’ve seen staining move down the brick, waiting means freeze-thaw cycles widen the damage through winter. We’ll tell you plainly which category yours falls in. Call (866) 472-2513 for an honest assessment.
Brands We Service in Lockhart
We install and service our brands across Lockhart, including HeatShield liner resurfacing, Gelco caps and covers, and Olympia Chimney components. For most common repairs we keep the parts on the truck, which means an older flue can often be fixed in one visit rather than scheduled around a parts run.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Company in Lockhart, TX
| Service | Typical range in Lockhart |
|---|---|
| Chimney sweep | $165 – $275 |
| Dryer vent cleaning | $120 – $225 |
| Chimney cap installation | $185 – $350 |
| Chimney cap replacement | $225 – $450 |
| Chimney crown repair | $450 – $1,250 |
| Chimney flashing repair | $275 – $650 |
| Chimney liner installation | $2,100 – $4,800 |
In Lockhart specifically, price moves up when we’re working on a chimney that hasn’t been touched in decades. Deep creosote or grease buildup extends the sweep time, and many older homes have flues with unusual dimensions that need custom-fabricated caps or liners rather than off-the-shelf parts. We quote a flat price before work starts, and that price is what you pay.
Neighborhoods We Serve in Lockhart
We work throughout the 78644 ZIP code, from the Victorian-era blocks near the Caldwell County Courthouse to smaller streets in the southwest and northeast pockets of town. Here are a few areas we’re in regularly:
- Lockhart’s historic district around the courthouse square and adjacent early-1900s streets
- The residential blocks south of City Park toward Plum Creek
- Neighborhoods off State Park Road near Lockhart State Park
- Streets around Lockhart Junior High and north toward the bypass
- Rural properties just outside town limits within 78644
Within town, we can usually schedule within a week. Properties at the outer edges of the ZIP code may add a day or two depending on route coordination.
Service Area – Cities Near Lockhart
Beyond Lockhart, we cover a corridor of central Texas communities that stretches from Kyle, TX and Buda, TX down through Uhland, TX and over toward Onion Creek, TX. If you’re just across a town line, call us and we’ll tell you honestly whether you’re in the current service footprint.
Serving Lockhart, TX — Our Local Coverage Area
We’re based in the Lockhart area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Chimney Company in Lockhart
Most chimney sweeps and dryer vent cleanings in Lockhart can be scheduled within 5 to 7 business days. Repair jobs depend on the scope, but if you have an active water leak or a failed liner, we treat that as a priority and often get out faster. Call (866) 472-2513 and ask about the current schedule.
Most routine chimney sweeping, cap replacement, and crown repair in Lockhart does not require a permit. Liner installations and structural rebuilds can fall under building code review depending on scope, and we’ll let you know upfront if your job crosses that line so there are no surprises with the city.
We’re based in Anderson Mill but maintain a full service presence in Lockhart with crews working here weekly. Since 2017 we’ve built a repair book specific to Lockhart’s older housing stock, so your chimney isn’t a new puzzle for us when we arrive. Schedule like any local company would: by zip code and urgency.
What happens when you call
- 1A real person answersNo phone trees — talk to a local chimney cleaning pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Lockhart Customers Say
"Good work. The written inspection report took about a week to arrive after I asked for it, which was slower than I expected."
— Adriana Delgado"Fireplace had never drawn properly since we moved in. He found the damper was only opening halfway due to a bent linkage and fixed it in ten minutes."
— Dustin Barrett"Drop cloths everywhere, HEPA vac, and not a speck of soot on the carpet. I'd been dreading the mess for nothing."
— Steve Doyle