Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Chimney Company in Hornsby Bend, TX
Chimney repair in Hornsby Bend usually starts with a camera inspection, because a lot of what we find out here was never inspected in the first place. Homes in the 78725 ZIP are mostly rural or semi-rural builds from the 1990s through 2010s, and plenty of fireplaces and wood stoves were added after construction without a permit. That means our work here leans heavier on diagnosis and correction than it does in a tract neighborhood in Austin. If you’re seeing staining, drafting problems, or just haven’t had the flue looked at since you bought the place, call Oakgrove Chimney Sweep at (866) 472-2513 and we’ll tell you exactly what’s going on.
Why Hornsby Bend Homes Are Different
Hornsby Bend sits in eastern Travis County without a municipal fire marshal or local chimney-sweeping ordinance, so there’s no one requiring homeowners to maintain a flue. That changes the work. We routinely open up fireplaces in manufactured homes and ranch-style houses where factory-built chimney sections were extended or swapped by a previous owner using whatever pipe was on hand. The fix isn’t always sweeping; it’s often correcting an installation that should have failed an inspection years ago. Our technicians treat a first visit as a Level 2 camera inspection by default, because in this area the flue you can’t see is usually the one carrying the risk.
The climate compounds it. Fireplaces and freestanding stoves sit unused through long, hot central-Texas summers, which gives creosote time to harden into a glaze and gives wasps, birds, and squirrels time to nest. Then a hard freeze in December or January pushes everyone to light the first fire on the same weekend, and the flue they haven’t thought about since March gets asked to perform under load. Around here, most of the fuel is oak and pecan, often burned before it’s fully seasoned. That’s a recipe for heavy creosote in a short heating season, and it’s why we recommend a sweep and inspection before the first cold snap, not after it.
We’ve worked Hornsby Bend long enough to know the difference between a flue that’s dirty and one that’s dangerous. Oakgrove Chimney Sweep has served Hornsby Bend since 2017.
Styles & brands we work with
Our Main Hornsby Bend Services
Most Hornsby Bend homeowners reach out for one of two reasons: the fireplace hasn’t been cleaned in years and they want it safe for winter, or the dryer vent has never been addressed and they’re starting to understand the fire risk. We handle both as full-service jobs with the same diagnostic rigor.
Chimney Sweep in Hornsby Bend
A proper sweep in Hornsby Bend is more than removing soot. Homes here burn heavy-creosote woods like oak and pecan, often in stoves that sat unused through a long, hot summer. By the time we arrive in October or November, the creosote can be baked hard, and the animals have had months to move in. We sweep the entire combustion path, check the cap and damper, and run a camera when we suspect the flue has been modified. If you haven’t booked a cleaning in a year or longer, read more about Chimney Sweep in Hornsby Bend.
Dryer Vent Cleaning in Hornsby Bend
Dryer vents in rural Travis County homes are often long, multi-turn runs through attics or crawl spaces, installed when the laundry room was a DIY addition. Lint backs up fast in those conditions, and a blocked vent makes the dryer work harder, run hotter, and eventually become an ignition source. Our crew is chimney-trained, which means we think about the whole vent path as a combustion exhaust system, not just a duct to vacuum. If you can’t remember the last time the vent was cleared, see Dryer Vent Cleaning in Hornsby Bend.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Chimney Repair in Hornsby Bend
Chimney repair in Hornsby Bend frequently means undoing someone else’s handiwork. We see manufactured homes with factory-built chimney sections that were cut, swapped, or extended with whatever parts were available at a hardware store, not the listed components the system requires. Add in central Texas weather – hard freezes, heavy spring rains, and a summer hot enough to crack mortar – and you have flues that leak, draft poorly, and in the worst cases send exhaust into the house instead of up the stack. This is the service where Oakgrove’s full-scope approach matters most: we sweep, we inspect, we repair, and we don’t hand you off to a third party. That’s the whole point of our Chimney Repair work.
Chimney Cap Installation
Signs you need it
Water in the firebox, animal sounds in the flue, or a visible rusted or missing cap are the typical signs in Hornsby Bend homes.
What it costs in Hornsby Bend
A chimney cap install in the Hornsby Bend market typically falls in the $220 – $520 range depending on cap material, flue size, and roof access.
How we do it
We measure the flue, select a listed cap from our stock (often Gelco for standard profiles), secure it to the flue tile or crown, and test for any draft changes.
Chimney Cap Replacement
Signs you need it
Rust-through, missing mesh, a cap that’s shifted, or a visible gap between the cap and flue tile all mean the existing cap is no longer doing its job.
What it costs in Hornsby Bend
Replacing a damaged cap costs about the same as a new install, between $220 and $520, depending on the flue size and whether we need to correct any underlayment.
How we do it
We remove the old cap, inspect the flue tile beneath it, and install a correctly sized replacement that keeps rain, embers, and animals out.
Chimney Liner Installation
Signs you need it
Peeling wallpaper near the fireplace, a persistent campfire smell inside, or flue tiles that are cracked or missing on the camera report point to a liner problem.
What it costs in Hornsby Bend
Liner installation here runs about $1,300 – $2,600 depending on the flue height and whether we’re relining a masonry chimney or connecting a wood stove.
How we do it
We confirm the sizing, drop the proper listed liner system (usually DuraFlex), insulate where needed, and lock it in with a top plate, cap, and proper connector.
Chimney Flashing Repair
Signs you need it
Water staining on the ceiling near the chimney, damp drywall in the attic, or visible gaps between the flashing and the roof are the telltales.
What it costs in Hornsby Bend
Flashing repair in the 78725 area is typically $380 – $850 depending on how much of the existing flashing must be removed and what condition the surrounding roofing is in.
How we do it
We cut back the old flashing, install step and counter flashing in the right layers, and seal the transitions so water runs off the roof instead of behind the chimney.
Chimney Crown Repair
Signs you need it
Hairline cracks across the top of the chimney, spalling brick below the crown line, or standing water on the crown after a rain are common signs in Hornsby Bend.
What it costs in Hornsby Bend
Repairing or resealing a crown in this market ranges roughly $290 – $650, depending on whether we’re patching with a flexible sealant or rebuilding the crown form.
How we do it
We clean and prep the crown surface, repair the cracks or repour as needed, and apply a weather-resistant crown coat so water doesn’t migrate into the flue.
What Chimney Repair Costs in Hornsby Bend
| Item | Typical range in Hornsby Bend |
|---|---|
| Chimney cap installation | $220 – $520 |
| Chimney flashing repair | $380 – $850 |
| Chimney crown repair | $290 – $650 |
How do I know if my chimney needs repair or just a sweep?
A sweep removes creosote and debris; a repair fixes a structural or installation problem. In Hornsby Bend, many flues need both, because undocumented DIY chimney sections are common. The camera inspection tells us which category you’re actually in. Call (866) 472-2513 and we’ll walk you through what we see.
Can you fix a chimney in a manufactured home in Hornsby Bend?
Yes, if it’s a listed factory-built system. The problem we often find is that sections were swapped with non-compatible parts. We bring it back to listed configuration or reline it, so the flue vents correctly and safely. We see this in Hornsby Bend regularly.
Brands We Service in Hornsby Bend
We stock and install parts from HeatShield, Olympia Chimney, and Famco, among others. That means a liner section, cap, or flashing component is usually in the truck, not on a two-week backorder, and the repair gets finished the same day. See our brands for the full list of what we work with.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Company in Hornsby Bend, TX
| Service | Typical range in Hornsby Bend |
|---|---|
| Chimney sweep (Level 1) | $150 – $250 |
| Chimney sweep with camera inspection | $250 – $400 |
| Chimney cap installation | $220 – $520 |
| Chimney cap replacement | $220 – $520 |
| Chimney liner installation | $1,300 – $2,600 |
| Chimney flashing repair | $380 – $850 |
| Chimney crown repair | $290 – $650 |
| Dryer vent cleaning | $100 – $200 |
What moves the price up in Hornsby Bend is access: long set-backs from the road, steep metal roofs on manufactured homes, and flues that were extended with non-standard parts all add labor. The price we quote before the work is what you pay – no added fees after the fact. Call (866) 472-2513 for a firm number on your specific job.
Neighborhoods We Serve in Hornsby Bend
We cover the entire 78725 ZIP, from the small subdivisions off FM 969 to the acreage lots along the Colorado River bottom and the single-family streets near the treatment plant. Typically we can schedule Hornsby Bend calls within a few days, often sooner during the fall shoulder season when homeowners are thinking about the first fire.
- Hornsby Bend Acres
- Webberville Road corridor
- FM 969 corridor
- Colorado River bottom acreage
- Thon Hill Road area
Service Area – Cities Near Hornsby Bend
Oakgrove Chimney Sweep works throughout eastern Travis County and the surrounding area. If you’re nearby, we also serve Garfield, Manor, Rollingwood, and the larger Austin market. Same crews, same camera-first approach, same professional-grade materials.
Serving Hornsby Bend, TX — Our Local Coverage Area
We’re based in the Hornsby Bend area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Chimney Company in Hornsby Bend
Most Hornsby Bend calls are scheduled within two to five business days. During October and November, when the first cold snap hits, our calendar fills faster, so call ahead if you want the flue swept and inspected before you build the first fire. The estimate call is free.
Hornsby Bend is unincorporated Travis County, so there’s no local fire marshal or chimney-sweep ordinance requiring a permit for most cleaning and repair work. If we find a fire hazard, we’ll document it in the inspection report and recommend the correction, even though there’s no municipal body forcing the issue.
Yes, and in Hornsby Bend that’s a very common request. We run a Level 2 camera inspection as our standard first diagnostic on undocumented installations, which gives you a photo record of the flue before any repair recommendation. We won’t suggest work you can’t see evidence for.
Get in touch with Oakgrove Chimney Sweep at (866) 472-2513 for a free estimate on chimney repair, sweeping, or dryer vent cleaning in Hornsby Bend. We’ll tell you what the flue needs, and what can wait until next year.
What happens when you call
- 1A real person answersNo phone trees — talk to a local chimney cleaning pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Hornsby Bend Customers Say
"Creosote buildup was worse than I realized. He measured it, showed me the glazing on the flue with the camera, and was honest that we were closer to a chimney fire than I wanted to hear."
— Hector Garcia"Swept it, capped it, and installed a proper damper. The downdraft smell in the summer that we'd lived with for years is gone."
— Alma Salazar"Crown was cracked and taking water. Repaired it rather than quoting a rebuild, which the previous company had pushed hard for."
— Neil Novak