Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Dryer Vent Cleaning Across Wells Branch
Dryer vent cleaning in Wells Branch typically runs $129 to $249 for a standard single-story home with an accessible exterior termination, and most jobs take under an hour. If you’re in the 78728 zip code and your dryer has started taking two cycles to finish a load, the problem is rarely the appliance itself. It’s usually years of lint compaction in a duct run that was installed when your house was built in the 1980s or 90s.
We know Wells Branch because we work here regularly. The subdivisions off Wells Port Drive, the streets around Katherine Fleischer Park, the older sections near the MUD office on Shoreline Drive. When we roll up to a house in this area, we already have a good idea what we’re going to find inside the duct. Call (866) 472-2513 and we’ll schedule a time that works for you.
Why Oakgrove Chimney Sweep Is Wells Branch’s Preferred Dryer Vent Cleaning Company
Our Dryer Vent Cleaning team is built different from a general duct-cleaning outfit. We come from the chimney trade. That matters in Wells Branch because the dryer duct and the chimney chase often share the same exterior wall or roof penetration on 1980s and 90s builder-grade homes. A company that only knows ducts misses what’s happening two feet away on the same chase. We don’t.
Wells Branch homeowners call us because we explain what we find in plain language and show you the camera footage before we recommend anything. If the vent is clean and the dryer needs a new heating element, we’ll tell you that. If the duct is packed solid and the termination hood is rusted through from Central Texas humidity, you’ll see it on the screen. No scare tactics, no invented problems.
Glen Whitaker built Oakgrove around a simple idea: sweep, inspect, repair, one company. That’s why we stock and install professional-grade parts from DuraFlex, Famco, and Copperfield rather than big-box substitutes. When a Wells Branch home needs a new termination hood or a proper cap over a shared chase, we have the right part on the truck, not a universal-fit piece that leaks in a year.
Styles & brands we work with
Our Dryer Vent Cleaning Services in Wells Branch
Dryer Vent Cleaning With Camera Inspection
Every dryer vent cleaning in Wells Branch starts with a full camera run of the duct. We don’t just brush and walk away. The camera shows us exactly what’s in there: lint compaction at the transition elbow, nesting material, crushed flex sections, or a damper that’s stuck shut. Most Wells Branch homes built in the 80s and 90s used flexible foil or semi-rigid duct that sags and catches lint. We’ll document what we find and show you the before and after.
Chimney Cap and Termination Hood Replacement Over Shared Chases
This is a Wells Branch specific failure we see constantly. Your dryer duct and your factory-built fireplace flue often exit through the same exterior chase. When the chimney cap goes missing, birds and squirrels nest inside, and that debris ends up blocking the dryer duct termination too. We’ll replace the cap and the dryer hood together so both venting systems stay clear. We use Gelco and Famco components for a proper fit on 1980s-era factory-built terminations.
Level 1 Inspection on Dormant Factory-Built Fireplaces
If your Wells Branch home has a fireplace that’s never been lit, you’re not alone. A lot of these houses were marketed with the fireplace as a decorative focal point, and that’s how it stayed. But an unused flue still needs inspection. Rust, wildlife, missing caps, cracked factory-built firebox panels. We’ll run a Level 1 inspection while we’re already on the property for the dryer vent, so you know whether that chimney is safe to use if you ever decide to light it.
Full Duct Run Cleaning for Long 1980s and 90s Runs
Some Wells Branch floor plans put the laundry room on an interior wall with a duct run of 15 to 25 feet before it reaches the exterior. That’s a recipe for slow drying and fire risk. We run a rotary brush the full length of the duct and verify airflow at the termination with a manometer. If the airflow is still weak after cleaning, the camera will show us why.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Common Dryer Vent Cleaning Problems We See in Wells Branch Homes
- Shared chase with a dormant fireplace. The dryer duct and a never-used factory-built flue terminate in the same chase. A missing chimney cap lets birds and squirrels nest right where the dryer duct exits, and the homeowner blames the dryer.
- Rusted termination hoods from humid summers. Wells Branch gets hot and humid from May through September. Exterior dryer hoods exposed to that moisture rust out, the damper flap binds shut, and the dryer can’t push air outside.
- Sagging or disconnected flex duct behind the wall. Builder-grade foil duct from the 80s and 90s sags and separates at the joints. The dryer runs, the air blows into the wall cavity instead of outside, and the laundry room feels like a sauna.
- Duct runs that were never cleaned, not once. Many Wells Branch homes are on their second or third owner. A lot of those owners never knew dryer vents needed cleaning. We routinely pull 10 to 15 pounds of compacted lint from a single duct run in this area.
See the difference
Before
After
Before
After
Before
AfterPricing for Dryer Vent Cleaning in Wells Branch, TX
A standard dryer vent cleaning in Wells Branch runs $129 to $249. A short, straight duct on a single-story home with easy exterior access comes in at the low end. A long run, a second-story roof termination, a severely clogged duct that needs extra brush passes, or a rusted termination hood that needs replacing pushes the price toward the top of the range. Adding a Level 1 chimney inspection during the same visit is $149, which saves you a separate trip charge later. We give an exact price before we start, after we’ve seen the duct layout and the exterior termination. Call (866) 472-2513 for a free estimate.
We Also Serve Cities Near Wells Branch
Our crews work throughout northern Travis and southern Williamson County. When we’re not running calls in Wells Branch, we’re in Windemere, Pflugerville, Anderson Mill, and Jollyville on the same week. If you’re just over the line from Wells Branch, we’ll still get to you without a long wait. The same pricing applies across all of these communities.
Serving Wells Branch, TX — Our Local Coverage Area
We’re based in the Wells Branch area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs – Dryer Vent Cleaning in Wells Branch
Yes. The dryer vent and the fireplace are separate systems. The dryer vent gets clogged with lint every time you run the dryer, whether the fireplace has been lit or not. In fact, in many Wells Branch homes the dormant fireplace chase shares an exterior wall with the dryer duct termination, so an uncapped flue can let birds and squirrels nest right where the dryer exhausts too. Call (866) 472-2513 and we’ll check both on the same visit.
In most Wells Branch homes, it’s a partially clogged duct run. These houses were built in the 80s and 90s with foil or semi-rigid flex duct that sags, catches lint, and restricts airflow. When the dryer can’t push air outside, it takes longer to dry clothes and the appliance runs hotter than it should. A camera inspection will show exactly where the restriction is.
Yes. That’s one of our standard Wells Branch service calls. We brush the dryer duct, run the camera, then inspect the factory-built fireplace and flue while we’re already there. It saves you a second trip charge and gives you a complete picture of what’s venting on that side of the house.
Factory-built fireplaces from that era typically take a manufacturer-specific termination cap, not a universal masonry crown cap. We stock Gelco and Famco caps and terminations in the sizes those 1980s-era units used, so we can usually replace a missing or rusted cap on the same visit without special ordering. The cap matters because an uncapped flue on a dormant fireplace is exactly how squirrels and birds end up nesting in the chase next to your dryer duct.
No creosote, since creosote only forms when wood burns. But you should worry about rust, wildlife debris, and missing caps. The humid Central Texas climate corrodes metal fireboxes and dampers even in unused fireplaces. Some Wells Branch homes also have flues that were never properly inspected when the house changed hands, so hidden damage goes unnoticed for decades. That’s why we recommend a Level 1 inspection even if the fireplace has never been lit. It tells you whether the system is safe if you ever decide to use it.
If your dryer is slow, your laundry room feels humid, or you haven’t had the vent cleaned since you moved into your Wells Branch home, call (866) 472-2513. We’ll get you on the schedule, show you the camera footage, and give you an honest read on what needs work and what can wait.
Written by Glen Whitaker, Owner at Oakgrove Chimney Sweep, serving Wells Branch and the surrounding communities.